Round Sinker Mold With 9 Cavities and 1/4-Ounce How to make sinkers: 1. Ensure you are wearing protective clothing and all care must be taken when heating and pouring lead. 2. Put scrap lead into saucepan and heat until molten (lead will normally melt at 650 degrees). 3. Once lead is molten use a cooking spoon to take away any impurities that have risen to the top. 4. Take your coat hanger wire (wire is only used when making sinkers that require a hole in the centre) and place within the mould. 5. Using the tongs grab tour mould carefully and have the pouring cavity facing you. 6. Pour molten lead into mould until cavity is full. 7. It is recommended the mould be preheated before use. 8. Once mould has been heated up and your lesd is fully molten and clean you can proceed to pour the lead in to the cavity. 9. Wait 10 seconds and using pliers pull wire out then proceed to open mould. 10. Using your pliers snip the excess lead of the top of the sinkers. 11. Good luck and remember to always take care. 12.When disposing of unwanted lead please take note of your local authority about appropriate methods. Warning: 1. Lead is a toxic material 2. Use PPE when handing moulds 3. Use dry moulds as water can cause molten lead to explode
| Item Weight | 8.8 ounces |
| Shape | Round |
| Color | Silvery |
| Material Type | Lead |
T**T
Using it for slingshot ammo
This sling shot ammo mold is an absolute game-changer! Now, I can make my own ammo that's as accurate as a hungry seagull eyeing my picnic sandwich. It's so easy to use that even a squirrel with butterfingers could handle it. I've upgraded from slinging pebbles to crafting perfectly shaped projectiles. Say goodbye to misfires and hello to precision pelting – it's the secret weapon every backyard warrior needs! 🌰🎯😂
F**R
Works ok for the money. Pretty sloppy.
It works, but it’s very cheaply made, and there’s a lot of clean up to do on your sinkers.
A**N
Works fine
Works good just a little to big for what I was wonting to use it for.. but I'll have a use for it down the road
J**
👍
A little hard to remove the center fill rod (clothes hanger) but it still makes great sinkers
M**N
Could have been better.
Some molds need to be resurfaced and cavities need some attention.
A**Z
Garbage service
This product and / or seller is a piece of garbage, it arrived in an open "original" package but one of the two pieces of the mold is bent. Since it is made of molten aluminum it is plain to see that the piece was not bent during the delivery, it would have cracked if anyone tried to bend it. It is clear that the packaging was opened in the warehouse to switch a defective part for a good one, me receiving the bent (defective) one.
K**
A+++++
Now to get my melter then I will be good
C**R
Great Product!
This a fantastic mold. I use it for lead ammunition for slingshots. Perfect size for shooting. Will buy another!
Trustpilot
1 month ago
1 month ago
