Seismic Audio Speakers Dual XLR Female Connectors, Stainless Steel Wall Plate

It works well. Very Pleased.

It's about 60 / 40 with DEFECTIVE items from Amazon. But the XLR Plate itself works just fine once I got one that wasn't defective.

Like another reviewer, I had problems removing the protective film. Maybe the film adhesive had been on too long or maybe it got really hot in transit, but it was very hard to get off as the film would break rather than peel. Once I had the bright idea to use a heat gun on it the problems went away. Once hot the film peeled right off! The only other problem I have with these plates is that they are designed for the connector to be mounted to the front of the plate. This makes it a huge PITA to swap a plate for whatever reason since you have to de-solder the connectors. I was able to mount the connector to the back of the plate and it works OK, but the cables can be a bit hard to disconnect since the release lever is almost too short for this configuration. Overall I'm happy with these, but a slight redesign would be welcome. They look very nice and function very well in their standard configuration.

Works

Quality made, look great!

Arrived with protective adhesive film in place. That would be great because it keeps the plate looking unblemished and prevents small scratches, BUT!! To completely remove the film one must completely dis-assemble the wall plate! Both plugs have to be removed by removing the 4 screws and then the whole thing re-assembled. The whole issue could have been avoided with simple packaging changes.

We needed these to run DMX cables through an interior wall to an exterior wall and work great!

We are not pros, but a few of us are working at upgrading and expanding our Church Sound System. We need more microphones and we will be relocating some of the wall plates that have the XLR mic inputs. The last thing any of us want to do is get down on the floor or in some confined place and solder microphone wires to the backs of traditional solder-type XLR Connectors like you see on the back of these Seismic Audio SA-PLATE12 Single XLR Female Connector Stainless Steel Wall Plates. So we bought these face plates with removeable connectors so we can replace them with Neutrik NA3FDM XLR D Series 3-Pin Female to Male Adapters and take the modular route with ready made microphone cables.