C4Labs Zebra Zero4U Case – for Raspberry Pi Zero/Zero W & Zero4u USB hub Rev 2 (Black Ice)

It took a little tweaking but I was able to assemble this easily and I can be bad with this stuff. The screws are long enough, you just need to build it correctly and follow the instructions. A good small screwdriver helps when you are screwing on the top screws at the end!This makes the pi zero look a lot better than other cases and the heatsink is perfectly adequate. It has a window at the top that's perfectly cut out. It's also kind of cool because it shows off the blue color of the zero4u power indicator brightly through the clear material and there's a subtle glow from the bottom. This is the best solution to make a zero more usable for newcomers etc. Very nice looking and good craftsmanship. My friend also has a pi 3 case made by this company that he bought at microcenter and it's great. I strongly recommend this.

Looks cool but with that being said the installation was fairly difficult. Parts fit tightly to the boards and one of the thinner ones cracked when trying to get the USB board inserted into it. Pre-fit everything first and file any tight openings to fit.My major gripe is that the screws were not long enough. Could not use the rubber feet or the last piece of the case. Even then there was barely enough length to screw a into the nut a few threads. I will at some point replace the included screws.Will not buy again and cannot recommend. We will see how long it holds up in use.

I'm building a pi-hole/webcam device and this works perfect! I have a pi 4 as well and it kinda works as a troubleshooting/more portable pi4 rig. Found the hub part on adafruit.com (great site btw)- get it WITH the pogo pins. (#3298 / 2021)