HilitandRound Belting PU Belt Polyurethane Round Belt for Drive Green 5mm x 10m

I have a small motor that needed a fan belt and the belt was no longer available. This allowed me to make my own by cutting it to length, and then fusing the ends by running both ends over the opposite sides of a thin steel plate and fusing them together as they cleared the plate. I heated the plate using a propane torch until it was red, and no direct fire was needed for the fusion of the ends. It works fine and I have more than enough left over to replace it if it breaks as the original did.

The media could not be loaded. I used this solid round plastic to make 7 new belts that drive a trumel that sifts dirt. This product is perfect for my needs. Highly recommend.

This stuff is so fricking fun to use. I made belts for junk that doesn't use belts???? Really???Yes. My bench grinders do not need belts but I lined up three bench grinders back to back and made a belt to go from one powered up unit (AFTER it's set up) to the bench grinder behind it.The first grinder was easily able to spin both grinders simply by wrapping the belt around each 1/2" shaft melting the ends together, then powering on the first grinder.I WAS AMAZED! It really worked. the belts did not get loose and they did not break???? I ran it for 30 minutes and not a single damn problem. Why can't everything work like this.Great stuff. I'll keep it around my shop always now.

Take a utility knife blade (AKA box cutter blade) like ASIN B015W3AKDQ from Amazon. Clamp one end of the blade in a vice or vice-grip pliers (see picture) and heat the utility knife blade to red hot. Place one end of the length of belting against one side of the hot blade and the other end of the belting against the opposite side. Slide both ends of the belting off the hot blade so they touch and fuse. Hold for a minute or two until the joint cools and then carefully trim the joint.

Used for Rick tumbler replacement belts. Great quality, easy to use. Just cut to the zize you need, met the ends and push them together. Rock tumbler has been going 30 days on this belt with no issues

Fabricated some pulley belts for a DIY wire/bobbin/inductor winding machine.

Real easy to fuse and holds a strong fused joint.

I was a little nervous about "ease of welding" claim but it worked just fine. I was building a drum carder for my daughter.My setup:razor blade in vise gripsplywood with hole slightly bigger than beltmounted both in bench clampheated razor until red with torchpressed belt to both sides of razorput each side into plywood hole and pushed together for 1 mincut away plywoodTook me 3 tries to get it damn near perfect. Make sure the joint ends are perfectly 90 degrees.