Thermal Pad, 100x100x1mm Highly Efficient Thermal Conductivity 6.0 W/mK, Insulated Heat Resistant High Temperature Resistant Silicone Thermal Pad for IC SSD CPU GPU Heat Sink LED Cooling

Got this for my new Onewheel controller. Hasn't hit 100F since installing it. Seemed a lot more quality product compared to the thinner stock one I was replacing. Easy to cut to fit, and work with in general.

miner was overheating. took it apart and used this to replace the cracked thermal pads. worked very well and reduced temps significantly

Multitude of uses for my repair bench. Good quality, heat transfer, and thickness.

Old 1070 was having thermal issue when playing BL3. Made a big thermalpad fill so the board contacted the backplate through the pad. Also replaced VRM and VRAM thermal pads along the way in the front.The thermal pad came through the mail and there was a big fold mark on the protective films, the pad sandwiched between was unaffected. There were ~1-2mm silicon chipped off near the edge probably due to shipping and handling. Both could be avoided if the pad was shipped with a cardboard inserted and used do-not-bend stickers.

Great seller, good product, great price!

Used on a 3080 ventus 3x 10gb. 2mm thickness. I bought 3 by mistake and ended up with really high temps. turns out, because this pad is really firm, the thickness matters even more. So I got the 2mm, popped them on, and wham, -5c delta from stock. My pads were fine before, but I was doing a complete open, clean, painting shroud, and repaste of the card anyways. excellent value for the price. You could spend double this, and get about 7c less than these with gelid or NB, but for this price, excellent performance

Great product for the price. It elongates just a little bit when removing the film so better to do before laying down on the PCB components, but really easy to work with. I paired this with Grizzly 8 pads (grizzly has a bit better conductivity and texture is a little less maliable, good for high heat areas like VRAM, and others on baseplate) because I needed more surface area and the size of this thing was awesome! Plenty left over for future products. I think this product would've worked fine on all areas as the 1mm was exactly the same as the Grizzly but I wanted to ensure maximum heat dissipation. Overall, definitely would buy again!Note in my baseplate image the tan pads are the grizzly, and the blue pads are these AIYUNNI. I should've got a picture of the backplate where I used A LOT of this AIYUNNI, but trust me. This product does the job well.

Half is applied to macbook pro 2018 i9 intel. Bottom plate became very hot then mStand too. Then air cooled. Very satisfied