Electric Car Jack - 3 Ton Floor Jack 12V Truck Jack Stands Kit Scissor Car Lift Jack for Tire Change and Road Emergencies with Carrying Case

This is an excellent Jack for the cars and trucks out there. It did a great job before I had to replace it so I purchased it again. So I'm a repeat owner of this great Jack. The only reason why I replaced it was because my other one got damaged due to user error.

The media could not be loaded. Please read my notes here and watch the video.This is a good kit. The blow-molded case was a bit confusing. It is as if the included accessories changed a bunch, but they did not update the blow-molded case to go with it. Everything stays put for the most part, and the latches are solid.I don't think it saved me much time, but it definitely saved me a ton of sweat.This was the easiest tire change I've ever done; the hardest part was lifting the damaged tire into the trunk.The jack worked well under load. It's rated for "3 tons", and the vehicle it was tested on weights about 4200 pounds (and it's only lifting a corner).I don't think it would work for 50 cycles, but if it works for 3 or 5 I feel I would have gotten my money's worth. In 25 years of driving, I've had to switch to a spare maybe 5-6 times.Some metal shavings from the screw post came off during use, but you might see that on a new hand-operated scissor jack as well.The impact wrench was surprisingly powerful. Instead of the constant hammering I'm used to, this thing spins up a hammer and gives you a few solid hits. This should be all you need on most consumer vehicles with wheels torqued to spec.After tightening the lug nuts with 3 hits each, I lowered the car and tried to tighten further with the tire iron, but I couldn't move them at all. I have no doubt these are more than tight enough for travel.

Product came quickly. Quality is good. Works as said. The impact engine builds up before spinning. It has a little weight to it. It lift my SUV with ease. Easy to use. The case has velcro so it will not slide. Outstanding. Get a few good lifts out of it will be money well spent. Great value. Might buy a back up for a just in case, moment.

I just got it a few days ago and do not yet have extended experience using it. However based on my tests on multiple cars (Tesla, Lexus R350), this jack worked well. It has the right height to use on cars of both high and low clearance (the extension is needed with high-clearance cars). It appears to be slow when I ran it on the side, but once I put it under the car and started it, the speed is definitely fine in perspective. The box it came in is good. It has all the right grooves to tuck away the small parts in and the material feels sturdy as well.The hand crank is a joke though. I don't think you'll ever be able to use it to raise or lower a car. It takes a bit to engage, does not have a good mechanism to allow the handle bar to rotate freely (not sure what to call that), not to mention the extreme slowness to raise the jack. The slow speed is related to where the hand crank engages the gear and how much leverage it has. I wish the open end of the pull/release bolt was properly prepared to allow the use of a ratchet wrench to manually turn it when the motor fails.This is it for now. Will update if I have any problem using it down the road...

Just as described. And timely.

This jack is trash. I had jacked up my vehicle, but when I tried to lower it down, the control broke. I had to go out and buy a scissor jack JUST TO GET MY VEHICLE DOWN. This is the largest piece of trash I've ever purchased on Amazon! DO NOT BUY!

The media could not be loaded. Lo probé en una mini van y en un sedan de baja altura y funciona perfecto. Compré dos, uno para cada vehículo. La comodidad de la llave de impacto es ideal para mujeres pues les facilita el aflojando y ajuste de las tuercas. Muy recomendable

Jack is supplied with two support posts: 1) short for low ground clearance vehicles 2) tall for high ground clearance vehicles, SUV's etc. Jack worked great on our low ground clearance Mazda 3. However, to use on our SUV/4runner it was necessary to use the tall support post. Post wouldn't screw into the receiver/base any further than a quarter turn (the 1st thread only) leaving the post precariously positioned in the jack and very dangerous. I requested to return to Amazon and opted to get a replacement. Replacement arrived the very next day. Unfortunately, has the same manufacturing defect, so returning that one as well and getting refunded. Shame though, as I was really impressed with it after using on our Mazda.