KENUCO WMS WML PC110 DS-1272ZJ-110 Wall Mount Bracket for hik-Compatible Dome Camera Compatible with DS-2CD2143G0-I(S), DS-2CD2163G0-I(S), DS-2CD2183G0-I(S)

This thing is very well built. It has a little set screw so you can really lock the pieces in place and it comes with an extra since they're easy to lose. These set screws plus the screws they include to attach the camera have a little bit of thread locker on them. The rubber gasket that goes between the camera and the mount even has a nub that seals the notch in the camera where a cable would normally go out. The bottom line is it's very well built and a lot of thought went into designing this product.

It fit my application close enough. I have various cameras and I purchased this hoping it would fit my IP4M Amcrest cameras. It did. I had to make one small modification to the rubber gasket . I cut off a bump of rubber and use silicon caulk to seal a small hole/channel meant for the cable to come out the side in a flush mount scenario. The important part is that the camera Mounting screws matched up to the holes on the camera mount even though its not an amcrest wall mount bracket

Worked great for my 2142. The mounting holes are huge and so I used a 5/16 inch bolt. Also if you need any to have the cable out the bottom you will need to cut or drill the cutout. Solid piece of metal.

These seem to be well made, the camera and gaskets all lined up just right and installation was simple. It also came with some decent concrete anchors if one needed them.

This PTZ bracket does not fit the PTZ that meant to mount on it. The screw holes do not line up the with each other and the outer ring of the bracket is 10mm smaller (20mm diameter smaller) than the PTZ's outer ring. It is therefore unsuitable for the PTZ and task that is required.

Works great I'm just trying to figure out why the mounting holes are so big. I needed to use washers and it's not necessary but that's how it was designed. I'll order another one when needed.

I bought this camera mount for a project i was working on. It was well made and the finish we very nice. I recommend the unit.

Edited: FOUND TWO set screws floating loose in box. Thank you. Large expanding masonry bolts are large enough to hang a small child's swing from. Worse... the bolts use regular nuts instead of security nuts and have no covers, i.e. anyone can climb up and unscrew them and steal the camera and this camera mount.One word of advice... IF like me you’re lazy and find terminating cables to a crimp connector fiddly and you choose to use a Keystone jack be sure you have enough room in your cavity wall to get it inside as this mount barely has enough room to bundle a Keystone jack and a 1 ft patch cord. Should’ve gotten the Hikvision with the junction box: DS-1272ZJ-110B PC110B Wall Mount Bracket with Junction Box