Alnicov 50mm Metal Humbucker Guitar Pickup Covers for Electric Guitar, Chrome (Pack of 2)

These really spruced up by 2013 SG. Love em!

So I used this to mod my squier bullet mustang and let me tell you, even tho fit PERFECTLY on the pickups, it’s too big for the pick guard to fit so, if you really want them badly installed, I suggest making the holes of the pick bigger by sandpapering them with a 80-200 grit paper for like 30 minutes each. After that, the guards are great and stunning! Just don’t put to much gain on your guitar since it’ll make a really high pitch noise after that so if you’re mainly into indie, blue, rock, it’s great. Metal, not so much. BUT FUN MOD EITHER WAY :)

Ottimo prodotto a un ottimo prezzo

Utilisé pour habiller un Humbucker no name, ce capot est bien brillant. Il faut un fer à souder assez puissant et poncer les surfaces à souder, mais ça se monte plutôt bien.

Look pretty cool, I prefer the look of humbucker covers where you can see the screws, and almost ordered some with holes, but then measured the pickups (52mm at the bridge, 50mm at the neck), I realised the default pickups don’t have screws, just magnets, so covers with 6 holes would have looked stupid. These are fine though, perfect fit, and trim about 1mm round the outside of the humbucker holes in the scratch plate, just like the lovely chap on YouTube recommends. I can’t comment too much on tone, I just probably didn’t play it enough before changing the look, but it should soften the tone a tiny bit