Boot Switch Tailgate Release Handle for Discovery 3 & 4 LR015457

Spot on does the job, was easier to cut and rejoin only 2 wires took about 10 min to fit

Wrong Connector for 2009 Discovery 3 GS. DOES NOT FIT

The plug connector is the wrong size and wired incorrectly. On the right old plug as fitted to the vehicle on the left plug on the part.... The switch body itself does fit correctly and works if you cut the wires and splice them to the old connector....

Although advertised as suitable for a Discovery 3, the electrical connector does not fit. You will have to do a bit of DIY by rewiring your old connector.

Worked perfectly. Fitted to Discovery 4 HSE with rear camera no problem. Some say not suitable for vehicles with a rear camera but I found that I just untaped the very short loom in the car and the camera wire is seperate from the switch loom anyway. Took about 20 minutes to fit.

Received mine came to fit it number plate lights where correct but the plug for the switch was different ended up using the original plug and basically making it. Work by rewire

Was a different plug than on my 2010 discovery 3 so had to cut plug off and splice wires also was a very tight fit into hole but it does work

I installed this three weeks ago, it worked well initially but has already failed. Would not recommend