National Hardware N233-247 3219BC Wall/Ceiling Mount Single Pulleys in Zinc, 1-1/2 in.

Works.

I took this and welded it to a 1 inch square steel pipe, or tube. It got mounted into the legs of my Rohn 25 tower and a pulley for my Off Center Fed Dipole. I have another pulley at the bottom on a spring to keep tension on the line, so the antenna is now an easy up, and easy down antenna. The pulley stood up well to being welded, the heat didn't hurt it one bit. You can see that there is a pin to take it apart, I didn't take it apart to weld it, but i thought to take it apart to put grease on the pin, it will help keep it running smooth after being out in the sun all year long.

This is a quality made little pulley. I just needed a small pulley to install in an area where it wouldn't necessarily be noticed, but would be helpful to me. This met all my expectations. I installed it under the handrail of an upstairs banister so I could raise and lower a laundry hamper or a pack of water from one floor to the next. Also helps with bringing other small items up and down when you don't wish to make multiple trips. A simple rope was all that was required.

So far so good 😊, happy camper

Best price I could find anywhere and they were available from this vendor. No retail store could get them. Price was one third of other brands. Got them quickly and they were easy to install.

Given the cost and size, I wasn't expecting a lot out of these pullies. Turns out they're head-and-shoulders better than anything else I can find locally: solidly built, well designed, and easy to position/install. I'll buy more of these if another project calls for such.

This is mine. Quality looks good but I haven't used it yet.

Mounted it to a beam in my garage and I use it to hoist the hard top shell off the bed of my truck. And sometimes my friend, who weighs 250lbs. Being able to assemble it AFTER install of the base plate is a huge perk