UTG Leapers MT-RSX8S Inc Ss Picatinny Riser Mount, Black, 0.83"

Lightweight and rock solid. Comes with a torx wrench and a spare mounting bolt in case you strip one. It looks good on the rifle and doesn't move under recoil or from moderate bumps. Good quality finish holds up well.Excellent mount for Bushnell TRS 25 and Primary Arms mini red dots. With Magpul MBUS sights, the 0.83 inch riser gives you a nice lower 1/3 cowitness. The sights sit below the dot in the lower third of the glass when looking at the dot alone. The 1.0 inch riser will just barely cowitness, but you can only see the very top of the front sight blade when using the iron sights with MBUS and the aforementioned red dots. The 1.0 inch riser was too tall for me, couldn't see enough of the front sight post, and much of area around the post is blocked by the emitter with the TRS 25. I've not tried the 0.75 inch riser, but I suspect it offers an absolute cowitness with the TRS / PA / MBUS setups.Pro Tip: If your iron sights are zeroed in, you can easily zero in your red dot without firing a single shot. Just look through your iron sights in perfect alignment while adjusting the elevation and windage of the red dot so that the dot sits on the top center edge of the front sight post. Make sure you are looking through both front and rear sights in perfect alignment when you do this. This works regardless of the height of the mount or type of cowitnes, and some people think this is cowitnessing. It is not the same as an absolute cowitness, which might explain the conflicting info on riser heights and cowitness. All correctly zeroed iron sights and red dots will appear to be cowitnessed when looking through the iron sights, regardless of the height of the riser. However, with a lower 1/3 cowitness, the dot is also visible above the sights when you move your eye above the iron sights.

Worked perfect for my thermal scope. The price was great and has lasted 2 seasons and counting now. Seems durable.

Paid 9 smacks for it in dec 2024 on sale, sold and shipped by amazon . a well machined lightweight piece , it's a picatinny stacker , not aimpoint mount . its very low pro in design , makes my other mounts look bulky , The supplied hardware is GTG . notice the 5 star reviews are 80% that is usually a good indication of quality .. i would buy again and have referred product to others .

its small, light weight. I like most the fact that the screws are recessed. looks clean and smooth.

Stupid cheap, but still decent quality.

Use this mount on an MCK for a red dot. I know some guys say not to cheat out on your mounts, but I'm not a Navy Seal, so it will probably last longer than I would in a fire fight or survival situation. It fits. It looks good. And it didn't cost much. It's a winner in my book.

Good quality riser with co-witness to flip up sights. Sturdy, mounts well, fit and finish are flawless.

Light weight. Will buy again as needed.