Shark Corp 01-2312 12-Inch Carpentry Saw Blade

nice blade, easy change, wish it was cheaper, but well made, finished. just be easy on it. not for cutting trees.

these pull saws work extremely well for times when you don't want to drag out your skill saw or powered miter saw and only have a few cuts to make

I've been using these saw blades for a few years now. When it's new and sharp, it cuts very quickly. When it's no longer cutting as well, I can get a new one for not much money.

It's a good fit to my original Shark handle, but it's not quite as scary sharp as the original. Man, that original blade from 25 years ago would cut through hardwood with hardly any pressure. This one is OK but not the same.

Damage a tooth on a pull saw and your pretty much done - so the slip on blade guard is important to keep.

Excellent for trimming tree branches! Excellent for general use and has a very small accurate kurf.

In all fairness I haven't used this blade yet as it is quite fine tooth and haven't had the need yet, BUT I have purchased and used the coarser version with the Japanese pull tooth and they are the same blade just different tooth. If you are ordering this for your older Marples handle, they do fit, but you will have to get your Dremel out. Comparing to my old Marples blade these are a bit longer where it inserts to the handle on the upper finger. Also, the hole for the push button is a whiskey small. Now some folks report that theirs fit no problem at all so I will assume there is some variation in the handles.So if you don't mind doing a bit of "fitting" theses are a great replacement for the old handles, if you want plug and play, buy a new saw.

If you have not added a Japanese pull saw to your tool box, do it now! They cut accurately and quickly through most wood leaving a clean cut. After many years of use, ours needed a new blade and this is as good as the original.