40W 40-LED Motorcycle Tail Light Integrated Driving&Brake Light Turn Signal Lamp With License Plate Bracket for Harley Honda Yamaha Suzuki Kawasaki (Black)

Had to have these, bright, brake, running and turn signals with lighted license plate bracket. Looks like a jet engine on afterburners!

this is very durable and water tight so far . it's bright for lights and brakes but in my case it's not very bright for turn signals .. this is my fault because I have to replace those circuits on my 40 yr old motorcycle. I have tried several taillights and these have impressed me so far.

Installed this on my 1980 CB900C resto-mod as an inexpensive way to get it road worthy and match the minimalist style I wanted. It looks a little smaller than I had hoped but that is likely due to the width of my current seat. Functionally, it works as advertised and I'm told visibility is decent from my riding buddies. Better later in the day of course but still good for daytime riding.I dropped one star only because the license plate mounting holes are not nearly far enough apart without modification. Another minor concern is the gauge of the connecting wires. They are very thin but after 900 miles and the addition of some extra shrink tube protection it seems to be holding up quite well. I have not ridden in the rain and therefore cannot comment on wet weather durability.I did have to bend the license plate bracket in relation to the lights to match the contour of my fender but the license plate light still illuminates the plate well enough to not irk the local coppers. The provided mounting screws and high-density foam padding on the mounting side are a nice touch.All in all I'm pleased with the product and feel it should hold up fine until I upgrade or sell the bike. Thanks for reading and be safe out there.

Looks great

They look nice but not bright enough .

The media could not be loaded. Used this to add a brake light and turn signals to my DIY e-bike. Though turn signal not as obvious when braking, would recommend over the smaller turn signals for the price point.

I see a lot of people complaining about quality. I've had my lights installed for about 1000 miles and have had no problems so far. A couple precautions I took - I put a cushioning piece or rubber on the back of the lights. My oem lights had some cushion against vibration so I was just copying the design. Second, I reinforced where the wires connect to the circuit board with glue.

Great very bright lights