Durafix Aluminium Welding Low Temp Easyweld Rod + Brush

No its not welding - it is really a type of soldering, not quite brazing as its too cool, but used properly these are really ultra handy and I will definitely use more and more of these to fix cast or pressed alloy things. Just like all soldering, your base metals have to be ultra clean - no tarnish, no scale, absolutely bare bright metal. Then just warm up the metal and keep dabbing the rod against it so you know its hot enough. It is easy to melt the rod as that has little mass, but your target object has to be hot enough to take the solder. I've done a few cast alloys cases with broken lugs etc, fixed a pan the other day which had a hole pitted in it too. The solder/rod material itself is definitely harder than the alloys your brazing/soldering as when you file/sand it down its easier to take away the parent metal than the solder. If you have a weak little butane torch and your trying to warm up a 1kg casting you will fail as you'll never get enough heat into the repair target. But with a MAPP gas torch, clean bright metal and these rods - you'll be amazed what you can repair.

Firstly, I was disappointed to receive a couple of short rods, which made this item expensive for what it is.Secondly, it didn’t work when trying to weld two aluminium box rods together at a point just 38mm wide as the heat conduction prevented that small section from becoming hot enough to weld. The unqualified Item description is therefore inaccurate in my view.

Very nice product ! works well just watch you heat on small items ! shame it was supplied with a advert leaflet and no instructions !! go to durafix website and print them off before using the rods ! on the whole nice and easy to use ! I use a silverline brazing and soldering torch running on propane

Ok it was only £7.00 but two miserable soldering rods and a cheap wire brush.

Firstly, I was concerned as so many people have complained that this doesn't work. I was using it to fill spotweld holes in the rear of 40 year-old Landy. I cleaned everything thoroughly and then used the supplied ali brush to ensure it was clean. I heated the aluminum as directed then wiped the rod around the holes and it ran and puddled as stated. I moved the the second hole and repeated this and all was fine. So, it works on aluminum bodywork ... but... I used an entire rod just on the bottom of one rear panel. It would be great if it came with more rods.

I found Durafix simple to use if you follow the instructions. A great product that saves £££ at a welding shop/garage etc

I would not buy these again have tried several times to use them .never again what a waste of money

My first time with brazing aluminium. Instructions were brief so learnt as much as I could looking at you tube videos. Very pleased with the end result and would use again