Front & Rear Fender Flares Compatible with 2018-2023 Jeep Wrangler JL & JLU Unlimited Sahara, Off-Road Wheel Flares Liner 4 PCS (Not fit 4xe)

I don’t write reviews often but I feel compelled to for this. They fit my Rubicon JT so well, I want to thank the manufacturer. I design molded components for a living and I don’t think I could have done better.Skip the Mopar branded extensions and spring for these. Every hole lined up. No trimming. No heating and forming. Just drill out the old rivets and install. 20 minutes total. I even installed them with my existing Weathertech front mudflaps with NO MODIFICATIONS.Note - Buy the $20 rivet tool also. It includes more rivets of varying sizes and a trim clip removal tool.

Nice upgrade to my Jeep, fit is right at decent price, looks good and high quality!

Was easy to install directions were really good. Do you recommend buying the rivet tool to put these plastic rivets in helps keep the road film and mud and dirt off the sides of my Jeep and I do like the way it looks fit. It was perfect.

This product was packaged very well and arrived with rivets and screws needed for insulation. You do need a plastic rivet tool in order to complete the installation.I did not need to use a drill. I pried up a little on the rivet and used a tool to cut the rivet off. Installing the new rivets was very easy using a plastic rivet installation tool which you can buy separately for 17 or $18.Each Fender Flare is labeled very clearly as front or rear and left and right. I started the installation with the center most rivet and worked my way towards each of the edges of the fender flare. I had to hold the flare in place while I inserted the rivet but once I did everything matched up really well. There's very little gap between the fender flare and the original fender. It does look very nice and seems to be very good quality plastic. It seems very secure. Overall I'm very happy with this product and I expected to last a long time.Time will tell however if the plastic is of good enough quality so as not to discolor rapidly over time faster than the fenders do. I suspect using the same product I would use on the fenders to protect the plastic should work.

Orders the product to fit the JLU Sahara 4xe and High Altitude. The product sent a month later is not even close. even the instructions state for low fenders. The product does look nice for a regular JLU

These fit perfectly on Gladiator Rubicon high fenders. The fender flare extensions have rivet holes that align exactly with the stock fender holes, hence no drilling. Many Gladiator owners buy 2 sets of OEM Wrangler XR Mopar fender flare extensions, and put a set of fronts on the rear. But… that method requires you to drill new holes in the Gladiator fenders, as the front holes don’t align with the rear fenders. These Amazon flares eliminate the need to drill. So glad I found these.

Looks clean like it came from the factory. Wish it extended out another inch or two.

Amazing!!! Turned out so well and easy install. Just be patient when removing factory rivets so not to scratch anything. Was very impressed that the finish matched my fenders!