airgoo 4pin Adapter Cable, Only for Corsair Commander Core XT Controller's 4pin RGB Connector, Convert to 5V 3pin ARGB Connector (5V,Data,N/A,GND), Controller is not Included

Took less the 15min to fully install and setup icue. Now my Be quiet! light wing works on my corsair rgb hub.

I got this to sync my ARGB fans to iCUE, and it worked just as intended. My ARGB fans were daisy chained so I didn’t need any extra. It connected right away and the fans displayed normal brightness. It was a little expensive for what I got but I’d say it was worth it.

Worked great on my generic rgb fans connecting to a corsair hub. Tried it on a light strip, only lit 8 of the lights, the same number as in a fan, go figure. Not a problem of this device, it's a limitation of the Corsair iCUE software.

I'd had my Cooler Master Hyper 212 Halo Black Edition plugged into my MSI MAG Tomahawk JRAINBOW2 port, but couldn't control it with Mystic Light. It was continually in a rainbow wave color and set to max brightness (so basically the surface of the sun). I have mainly Corsair iCue components (RAM, case, keyboard, headset, mouse) and decided I'd try plugging this cooler fan into the Corsair Lighting CORE on my case with this cable.The LEDs started flickering constantly with red, green, blue, and white. I disconnected it and plugged it back into the motherboard JRAINBOW2 port -- and wouldn't you know it, I could address the cooler with Mystic Light...but while the overall effects would be applied, I still had some LEDs stuck in red, blue, green and white.I shouldn't have messed with it and just accepted I needed to either wear a welding mask while at my pc or apply 10% car window tint to my tempered glass PC case side. Luckily the mounting kit I ordered for my second, non-LED cooler came in.I would not recommend this converter for Cooler Master RGB fans. I feel like I'm in the world's worst nightclub until I can swap this cooler out after work.(For reference, every other LED component/accessory works fine, including the three case fans in my case that are also attached to the same lighting node)

It worked, fixed the mismatched fan led lights. Highly recommend!

These worked great to clean up the excess 3-pin adapters I had in place (because my motherboard only has 1 header). They connected to my Corsair Commander XT without any issues and were detected by SignalRGB.These did, however, not work with my Phanteks DS30 series fans. They did not show all of the LEDs correctly. Maybe a limitation of the Corsair product?

but until that happens, I'm glad there are people out there that can make and sell these little adapters. it's just a little piece but a huge problem solver. I've got a Corsair Ecosystem in my PC and a non-Corsair water block on my GPU (as well as some "cheap" RGB strips) which can function within Corsair. like I said, this is a great little problem solver.

If you are shopping for this very specific cable, you may or may not have burned by a low-quality version; but this is the good one. I wrote a similar review on their 3-Pin model as well, and both of these cables have been of terrific quality.