Trend CraftPro Slotting Router Cutter, 1/4 Inch Shank, 6.3mm Cutting Depth, 31.8mm Diameter, Tungsten Carbide Tipped, C145X1/4TC

Good value for money. Works well. Very fragile tips. One broke off in transport but still did the job whilst waiting for a replacement. Very sharp. Woyld reccomend this product.

Really pleased good product

Easy to use works perfectly

Very pricey compared to some you can buy, hence the lost star, but Trend quality is always good. If you want a cutter to last a good time then choose this one, if you only use it occasionally there are cheaper alternatives out there.

Bought to cut lots on lightweight ply boards to fit knock on trim.I've used it on a hand held router and on a router table and worked great on both. You can't really feel it cutting, you just feel the bearing preventing you going any further in. Makes really clean slots which makes knocking the trim on a breeze.Highly recommended.

I'm a time served joiner and I make my own shaker panel doors and I use this cutter to make the groove in my rails and styles which I then fit a 6mm mdf panel. It's a snug enough fit so the panel isn't loose while being glued and assembled. You can also change the guide bush so you can have different depths. I hoping I can get this re-sharpened at some point as the blades are starting to wear. If not I'll soon buy another.

Excellent quality product and service.

When it finally arrived I could see it was a good bit of kit. Supplied with different bearings for using different biscuit sizes. This is the proper kit for biscuit jointing with a router, unlike some of the other "pretend" bits out there. But is took more than 2 weeks for the product to eventually arrive. Just bad luck I suppose, but the first one never arrived. Then the company said they had posted a replacement, but that didn't arrive either. Finally they posted another first class and it arrived shortly afterwards. At least the company was obliging and did eventually rectify the problem.