🚤 Elevate Your Ride: Unleash the Power of Your Outboard Motor!
The MJ-1-DP Jack Plate is a high-quality, cast aluminum mounting solution designed for outboard motors up to 35 HP. With a 4" setback and a wooden mounting block included, it enhances performance and handling for skiffs, aluminum boats, and inflatables. Easy to install and built to last, this jack plate is perfect for those looking to optimize their boating experience.
| Item Dimensions | 16.61 x 12.79 x 4 inches |
| Minimum Height | 4 Inches |
| Material Type | Cast Aluminum, Laminated Wood |
| Style Name | Clamp-On Style |
| Load Capacity | 150 Pounds |
| Maximum Lifting Height | 4 Inches |
| Compatible with Vehicle Type | Skiffs, Aluminum Boats, Inflatables |
O**
It's solid! Test mount with clamps first to mount to correct height
Find the center of the transom. Use sturdy C-clamps to hold the mount on the transom, centered and at the correct height (cavitation plate of outboard in line with the bottom of the boat). Pick which divots that will go through the transom board after drilling and mark them with a pen or pencil. Make a mark around the mount after you're sure it's centered and at the right height. Remove the mount. Drill the holes with the correct size of your bolts (stainless steel hardware). Use a sharp drill and go slowly so you don't drift the hole (I used a drill press, aligned and clamped for each hole. After the holes are drilled, re-clamp the mount on the boat where you marked it and then drill the holes through the boat. I used silicone seal on the bolts, holes and fender washers with a lock nut on the inside, tightened well. I cut the excess threads off the bolts so they wouldn't snag things, like flesh and fuel lines.
J**Y
Great product, good price
C**Y
Great improvement
I have a 15” transom and a 15” short shaft motor but the motor still sat a few inches low. I was able to bring it up to a perfect hight for maximum performance. A 3” lift is a huge improvement when it comes to running shallow waters
T**E
Wood was a bad cut, jack plate worked though
The block of wood I received was not cut symmetrical or even near it, and had a dark bad spot running through the middle which cracked upon installing. I had to cut my own new piece to fit, and then it was fine. The aluminum plate itself is good to go but don't count on the wood being great. Definitely should've been better wood for being around water and clamped tight
J**N
Jack plate
Bought for long 25hp for short shaft transom. Works as advertised.
S**A
Simple and effective.
Exacly what I needed. Pushed the motor back 4 inches and up 3 inches. Major performance upgrade.
N**.
Showed up damaged
The aluminum seems like a solid piece to help lift my motor up. The packaging showed up undamaged by the laminated wooden block was delaminated and one of the laminated quadrants didn’t have much of any glue to hold it together.It’s now been on my boat and the aluminum oxidized quickly into powder.
P**X
Solide
J’avais un 25 hp long shaft sur un transom mesurant 16 pouces., l’eau lançé par le moteur montait sur l e transom. Cette plaque a remédié au problème . Facile à installer, solide
Trustpilot
1 month ago
5 days ago
