VEVOR Electric Hoist, 1320 lbs 120V Electric Winch with 328 ft Wireless & 14 ft Wired Remote Control, 40 ft Single Cable Lifting Height, Single/Double Slings, Lift Hoist for Garage Warehouse Factory

Nice product, Seems well built no issues as of now, easy to install, Fast delivery and Packaged well

The hoist works great. I use it to lift firewood to the second deck of my mountain cabin. Very good value product and works as advertised.

works great. if needing a rail to slide the hoist on, be sure to get the correct clamps to install the rail correctly and easily. This hoist works fantastic and is quick and quiet.

Installed as a hoist for my Jeep hard top in the attic. Working perfectly, not very noisy.

Works very well and the cordless controller is well worth the extra money. Only tiny little issue is the plastic stop on the cable is a little too small or the opening of the stop gate is a little too small big. When coiling up if you go too far and engage to auto stop feature, the plastic stop can go right thru the gate and get stuck there. You have to manually free it. I have mine in the attic of me garage so that means climbing the ladder and resetting it if that happens. Otherwise it works great and well worth the money.

This was exactly what I needed for my garage. Lifts my generator to the back of my truck. Lifts my outboard motor to install in the spring and take it back off in the late fall. No grunting and back strain no more. Also lifts front of my zero turn mower for deck cleaning and blade removal and install.Should have purchased earlier.

I bought one of these winches a few years ago. Works well so far, I use it to store my 5th wheel hitch up in the overhead of my shop. It only gets used when removing or reinstalling my 5th wheel. It is a little noisy but that is to be expected on a winch in this price range. So I bought a second winch to put on a rail in my shop. Surprisingly enough it is somewhat quieter than the first one and seems to function OK for what little I have used it. My problem is with the poor final assembly of the winch.Photo 1 - One of the welded on nuts used to install the hanger brackets on the winch was welded in at an angle.Photo 2 - The spring, washers and safety stop disc (Red Arrows) were assembled on the wrong side of the swedge. In this configuration the traveling block cannot be used. I removed the swedge, positioned the parts on the cable where they should have been and place a clamp where the swedge was and put on the traveling block.Photo 3 - The washer was the wrong size to keep it from being dragged into the traveling block. Fortunately I noticed the problem before it was under load or it would have damaged the spring and other parts. (Red Arrows)Photo 4 - I cut the end off the cable, removed the lower washer and replaced it with a fender washer (3/16" X 1 1/4") so the hoist stop would not bind with the traveling block and allow it to operate as intended. Then I put 1/8" cable clamps were the swedges had been.Evidently they don't do much for final inspection on these winches before shipping them. These were problems that should not have happened and if they did, they should have caught them prior to shipment. If I had used it like it was delivered the safety stop would not have worked as intended and likely damaged the winch or winch parts.

Great for the money