Time Delay Relay 10 Seconds 5 pin 12V 30A 5 pin SPDT

Used this relay to add day time running lights to an older vehicle. The delay is longer than 10 secs. but around 15 secs it comes on every time. Nice to have.

I used 1 of these to make a controller precharge circuit for my Ryobi ZTE 48volt zero turn mower. When I swapped out the 4yr old lead batteries for new lifepo4 batteries, the startup amp draw from the controller was tripping the BMS on the lifepo4 batteries. I used of this relaywith1 100w resistor ( https://www.amazon.com/gp/product/B0995NG7K7/ref=ppx_yo_dt_b_asin_title_o04_s01?ie=UTF8&psc=1 )and1 5pin relay ( https://www.amazon.com/gp/product/B078T3RC5T/ref=ppx_yo_dt_b_asin_title_o04_s02?ie=UTF8&psc=1 )to make a precharge relay circuit that precharges the controller capacitors for 10sec before engaging the main power relay.

does 10s delay when power applied to 86. if power removed, timer resets each time. As expected

After installing this relay, it did not change state after 10 seconds as it should. To be sure something wasnt wrong with the socket, I tested it on the benchand the relay still would not change state even after several minutes of being energized. Before giving up on this relay, I changed polarity to be sure, energized again, and still nothing.Hopefully other customers don't have a similar experience.

very good for my LED driving light . Recommened

I purchased this relay to add a longer delay to an electromagnetic lock for a gate. I couldn't get it to work and after bench testing a number of times finally realized that the trigger signal must be on continuously for 10 seconds before the switch in the relay is activated. My gate control only sends a 1 second trigger so it wouldn't work for me in my application. Granted, it was not what this was designed to do but reading the description I assumed once the trigger was activated then the relay would give either an always open or always closed circuit after 10 seconds.

Another reviewer posted the pins below. This is my first time using a time-delay, and I had 85 and 86 swapped, which worked fine with a regular relay, but not with the time delay. I had to go to the reviews, but I learned something! Convention is 85 to ground. I'm very happy this works- my electric fans don't come on right away so there is less load on the battery when firing up my Camaro- no slow crank!Pin 30 = constant 12v power (battery)Pin 85 = relay groundPin 86 = 12v trigger to activate relay and timerPin 87 = normally open (12v applied till after 10s)Pin 87a = normally closed (12v applied once trigger 12v applied to pin 86, power to pin 87a expires after 10s and switched power to pin 87)

Used it for for Diesel engine glow plug operation. Worked great.

Been using it for my FASS system in my diesel pick up, been working very consistently for acouple weeks now, I did take an average time and it only delays for 7 seconds not the full 10 but it’s consistent is the main thing. Just know walking into it it may not have the full 10 second delay but I think for the money it’s a good buy for sure

NO SIRVIÓ !

Used this on my boat to prevent oil pressure alarm from sounding while starting the engine.