7/8'' 22mm Thumb Throttle Cable Accelerator Control Assembly for TaoTao ATV Quad Go Kart Pit Bike-by DFuerdivn

this thing wears your thumb out if you aren't used to thumb throttles (i am not) but it works perfectly as a cheap and smooth replacement for the ultra cheap throttles that come with bicycle motor kits. when i got my kit and got it set up the cheap plastic twist throttle that came with it would hang and when twisting it you could feel it catcing internally. while i could have probably fixed it with a file and time, i instantly had no interest in that cheap plastic crap. another cool thing about this type of throttle is that if the handle grips that come with the bike you put a motor on are nice, you can keep the handle grips that came with the bike. i am still planning to get a decent twist throttle at some point because i prefer them, but i cannot subtract points for my own thumb fatigue, people use thumb throttles with the same or more resistance than this on 4 wheel atvs for hours at a time. my thumb just isn't used to it. to use it with a bicycle motor kit i had to extend on both sides and the core of the cable is still a hair long, but not enough to be an issue, if it is an issue in your case you can get new cable ends and chop it down a few mm.

Easy to install and is made with heavy duty materials. Great product and fitment. Even tho I put it on a bike.

Nice great little metal throttle housing, when I went to instal the cable to the inside of the housing the hole wasent Drilled wide enough for the cable. I had to drill the hole a little bigger to make it fit. Other than that it seems like a great throttle! Cable is a little flimsy but should hold up fine.

Excellent product so far! Installed it in place of OEM throttle on a Coleman CT200-u trail bike. Minor modification needed to open bar gap to correct spacing and also minor mod required (used a grinder) for the new throttle cable ball end. I don’t put this on the manufacture as this was my decision to use a unique throttle cable.

Used it on my mini bike and it works awesome. no complaints.

Cracked when I tightened it on my bar, cheap Pot Metal. It still held though and works.

Easily installed and prefect fit

Loved the product. It made out of mostly metal except the top cap I believe. Pretty heavy and functioned great. On a side note I got it for a mini bike because I like thumb throttles, you will have to get a simple throttle plate to bypass the governor arm. It's length of pull is about half of a twist throttle. Otherwise super happy!

Works great