DC HOUSE Hydraulic Power Unit 15 Quart Double Acting Hydraulic Pump DC 12V Power Unit Metal Reservoir for Dump Trailer Car Lifting

Came on the good shape works great

Great replacement on my 10K dump trailer.

Works for us for about 10 months then gives issues

lasted less than a week and the motor quit working.

Product is decent. Works as needed. Couple things. Comes with no instructions. For wiring or for operation if you are looking at the front of the motor the black terminal on the motor housing is where you connect your ground (or negative or black) lead to. Then if you look at the black cone on top of that motor mount (the solenoid) the nut on the right (or the 3oclock position) is where you connect your hot or red lead to.Now if you are using this for a one port piston you will only be using only one of the hydrolic points on the unit. You will want to use the port that is on the left, it will be the port with the plastic cap over a black thread. If you use the one on the right your up down controls will be reversed.The black connection on the housing can come off and that will allow you to use a 1/4 fitting. If you use the larger opening you will need I believe a 15mm hydralic connection.Lastly make sure you are using a large enough wire (#2 minimum). Depending on how far a run you have you might need to go larger. If not your motor will not run.

Placed this on my 2001 CHEV dump truck and put it to work right away. Installation was done by my friend, which takes a bit of know-how, dumps 2T fine. Tethered remote is helpful when dumping; When I overloaded it, it simply refused to dump the load BUT DIDN'T BREAK DOWN. Rebalanced the load and VOILA....kept right on working. Good product.

La unidad de potencia hidráulica superó por completo mis expectativas. Su rendimiento ha sido excepcional, con una respuesta rápida y una presión constante incluso en condiciones de trabajo exigentes. Es compacta, eficiente y muy confiable. Sin duda, una inversión que ha mejorado significativamente la productividad de mi equipo.”

Packaging is not sufficient to protect the electronic relays. The box arrived with the unit shipped upside down and the little clear plastic housing for the relays were broke. I took them off my old pump to make this one functional.I use this pump to operate an 18" cylinder on a tilt-bed shed delivery trailer. I searched until I found this specific model, with the box-shaped tank. The old pump on the trailer had a round tank. My old pump lasted about 3 years with nearly daily operation. Both the old and new pumps use a pair of 1" long bolts (not included) to mount, from the underside. On the old pump, these bolts kept breaking or coming out, due to the heavy vibration on the trailer. It had no other way to secure the pump. On this new pump, I added a piece of 8" channel iron to the trailer frame to support the box tank, and be able to strap it down to hopefully reduce the vibration and keep the bolts from breaking or unscrewing.Of particular note is that the brass hose fittings provided did not match up with my hydraulic hoses and I had to search several parts stores to find hose adapters that fit. The parts store guy said the female sockets in the pump manifold were "5 boss" size. My hoses used "6 boss".Also, this pump sometimes coasts and doesn't always act as a brake if you have a hydraulic cylinder extended with weight on it. There were some holes on the top of the pump motor housing that I was concerned might let water in, so I sealed them with RTV Silicon. This pump was mounted low on a trailer, so I sealed all the electronic parts with RTV.